How to apply Aquaply SLP Sealant.

	What is Aquaply SLP?	Properties
	How to apply	Available Colors

CONCRETE

As soon as forming and molding are removed, preparation should begin. Grinding, vacuum or abrasive blasting to a 1mm profile. Remove all laitance. Repair defects...sacking should be done to all vertical surfaces.
Remove all dirt and residue by vacuum and pressure washing with white vinegar solution, air dry. Do Not use petroleum fired heaters!

AQUAPLY-SLP will be the primer and top coat and can designed to utilize moisture and displace it. Please request moisture application formula.
Mix equal amounts by volume, parts A and B with a mechanical mixer at slow speed until completely mixed.

DO NOT ADD THINNERS

Apply SL-P by spray, roller epoxy grade) or squeegee, ...anti-foaming and bubble breakers have been added, however, bubbles will appear during the penetration of the coating... it is necessary to go over the area with a spiny roller prior to additional coats. Viscosity can be lowered by warming product.

Additional costs are applied when the prior coat is thumb print tacky. No sanding is required between coats if this procedure is followed. This allows for a wet on wet application forming an absolute bonding of coats.

EQUIPMENT

Clean mixing buckets

Epoxy grade rollers

Air or airless sprayers 1gal/min

Protective clothing,

Squeegees, trowels

Clean rags

Burlap sacks

Watch or clock

Mechanical mixer

spiny rollers

62PB or .029-.031 tip

gloves, dust mask, goggles

clean mixing sticks

cleaning solvent

sacking cement mix

brooms, shovels

TROWEL AND BROADCAST

When optimum thickness has been achieved, and the previous coat has geld, the aggregates may the troweled on or broadcast. Walk on time is 20-24 hours. Remove excess.

REPAIRS

Repairs to damaged or chipped areas are quite easy. Area should be segregated, cleaned and degreased. White vinegar and water are fine. AQUAPLY SLP then applied to the segregated area. Add appropriate fillers and colors to match.

Samples are maintained by the manufacturer to insure matching.

METALS

STEEL: Blasted to white metal, and treated immediately with metal treatment and immediately primed with AQUAPLY SLP. Previously premed surfaces need not be blasted. The SLP should be applied over the cleaned or pressure washed surface. Proceed with top-coats.

Because of the high solids and the solvent free nature of the products, wet film or thickness equals dry film thickness.

MAINTAIN ALL PRODUCTS IN SEALED CONTAINERS UNTIL READY FOR USE. DO NOT EXPOSE TO DIRECT SUNLIGHT OR FREEZING.